This settings specify where the bates numbering will be printed.
The Top left, Top right, Center, Bottom left, Bottom right settings sets an origin point. The X Offset(+/-) and Y Offset (+/-) settings specifies the distance of the top left corner of the bates numbering from the origin point. The units used to specify these values are set with the Units radio buttons. Supported units are tenths of a mm, hundreds of an inch and pixels.
For example, if the bates numbering’s origin point is set to Top left, the X Offset (+/-) is 100, the Y Offset (+/-) is 200 and the units are pixels, then the bates numbering will be printed on the page at position 100 pixels horizontally, 200 pixels vertically.
The Rotation field specifies the number of degrees the text will be rotated. This can be a positive or a negative value depending on the direction of the rotation.